Chapter 11
Calculation Settings

 11.1 GEARCALC
  11.1.1 Permissible deviation of ratio
  11.1.2 Tip shortening
  11.1.3 Manufacturing tolerance
  11.1.4 Calculate ratio face width to pitch diameter
  11.1.5 Tool addendum
  11.1.6 Use full radius (calculated at run time)
 11.2 AGMA 2001/2101
  11.2.1 Don’t use stock allowance and protuberance
  11.2.2 Definition of reference profile
  11.2.3 Manufacturing tolerance according to standard
  11.2.4 Stress cycle factors
  11.2.5 Calculation of tooth form factor
  11.2.6 Reliability
 11.3 Choosing Bending/Pitting safety factors
  11.3.1 Factor for minimal normal tooth thickness at tip
 11.4 AGMA 925
  11.4.1 Number of points for graphics
  11.4.2 X-axis unit