Part II
GEARCALC

9 GEARCALC in general
10 GEARCALC Wizard
 10.1 GEARCALC/ page 1
 10.2 GEARCALC/ page 2
 10.3 GEARCALC/ page 3
 10.4 GEARCALC/ page 4
 10.5 GEARCALC/ page 5
 10.6 GEARCALC/ page 6
11 Calculation Settings
 11.1 GEARCALC
 11.2 AGMA 2001/2101
 11.3 Choosing Bending/Pitting safety factors
 11.4 AGMA 925
12 AGMA 2001/ 2101
 12.1 Normal module
 12.2 Normal diametral pitch
 12.3 Normal pressure angle
 12.4 Helix angle
 12.5 Center distance
 12.6 Number of teeth
 12.7 Face width
 12.8 Profile shift coefficient
 12.9 Thinning for backlash
 12.10 Stock allowance
 12.11 Tool addendum
 12.12 Tool tip radius
 12.13 Basic rack addendum/Tool dedendum
 12.14 Tool protuberance angle
 12.15 Tool protuberance
 12.16 Quality according to AGMA
 12.17 Power
 12.18 Pinion speed
 12.19 Life
 12.20 Overload factor
 12.21 Load distribution factor
 12.22 Dynamic factor
 12.23 Driving
 12.24 Reversed bending
 12.25 Number of contacts per revolution
 12.26 Material
 12.27 Calculation of tooth form factor
13 Lifetime (Miner Rule)
 13.1 Calculating Lifetime according Miners rule
 13.2 Define a lifetime calculation
14 AGMA 925 - Scoring
 14.1 Type of lubrication
 14.2 Oil
 14.3 Profile modification
 14.4 Oil temperature
 14.5 Tooth temperature
 14.6 Scuffing temperature
 14.7 Standard deviation of scuffing temperature
 14.8 Dynamic viscocity at Θ_M
 14.9 Coefficient for pressure viscocity)
 14.10 Coefficient of friction
 14.11 Thermal contact coefficient
 14.12 Surface roughness
 14.13 Filter cut-off of wavelength